2001 honda accord no brake pressure?
I have changed the master cylinder and front pads and bled the lines using the 2 person method and yet i have no pressure at all while the car is running but while its off it seems to continuously gain pressure could someone help me figure this out please
If you can pump up the brakes, you probably have warped rotors forcing the pads apart. You can take the lines off the master one at a time and plug the outlet to see if it's the front or read giving you trouble. Make sure the calipers are sliding freely. Did you bench bleed the new master cylinder? If not you need too. Quit playing loud n - word rap music all the time and maybe it'd run better i've bench bled the new master as well did you bleed all of the wheels, any leaks at the wheels? Clamp off the rubber hoses at each caliper and see if the pedal is normal. If it is then release one clamp at a time until the pedal fails. That's the wheel where the problem is. You didn't change the rotors? That's one problem already. Are the caliper slide pins cleaned and lubed? HI well unless you have the engine running to produce enough vacuum fort the power assisted brakes it does not work anyway.
Did you bench bleed the new master cylinder? If not you need too.
Quit playing loud n - word rap music all the time and maybe it'd run better
I've bench bled the new master as well
Did you bleed all of the wheels, any leaks at the wheels?
Clamp off the rubber hoses at each caliper and see if the pedal is normal. If it is then release one clamp at a time until the pedal fails. That's the wheel where the problem is. You didn't change the rotors? That's one problem already. Are the caliper slide pins cleaned and lubed?
HI well unless you have the engine running to produce enough vacuum fort the power assisted brakes it does not work anyway.
- Karcher Honda Pressure Washer 2400psi Low Pressure? Hello every one I have a Karcher Honda Pressure washer 2400psi, when every I pull the trigger the first time it works fine. Then when I take the vavle unloader and the end where the air filter is on the pump, it works after a while for only one trigger pull. What's wrong?
- I need to replace my 2nd clutch pressure switch on my 1998 Honda Accord EX V6.Can i buy one aftermarket or should i go dealership? I bought one online from ebay and the harness snapped and so i gotta get another one. I'm not sure if the ones online are worth the money and i just would like some answers
- 94 honda accord with no break pressure? Car had no break pressure. No brake fluid leaks. Bled the breaks thinking that would solve the problem it didn't. Replaced master cylinder (not remaned) brand new. Re-beld breaks now the pedal has tons of pressure and acts normal with out the engine running but while the engine is running the pedal goes right to the floor with minimal breaking. I don't know what to do.