Can you bypass a starter on a 1990 Honda Accord manual transmission?
Can you bypass a starter on a 1990 Honda Accord manual transmission?
By this you mean, start the car without using the starter?
Answer is YES, the maneuver is called POP start, or Push Start.
You turn on the key, step on the clutch, put in 1st gear, then have the car pushed, or make it roll downhill, when the car is rolling (about 5+mph), quickly release the clutch and step on the gas pedal, but quickly step on the clutch again as soon as the engine fires up.
Is that the only way? Because some people can bypass the starter by, using a screwdriver and touch a certain part on the starter then the car turns on. Is that possible with the honda?
- Transmission going out on friend's 2004 Impala. Is it possible to install a manual transmission taken from a 1992 Honda Civic in this car? Not worth replacing trans on a car this old, but the engine and everything else are still perfect. My friend was able to get a free manual trans from a 1992 Honda Civic. But i'm not sure whether or not you can use a trans from a different vehicle
- Motorcycle starter over heated starter and only the solenoid clicked so i rebuilt the starter n tested it with a battery n it worked fine? Put it back in bike and again only the solenoid clicks… Is there a fuse for the starter or a relay i may have blown? 1988 honda hurricaine 1000F i'm ready to hang it up but the bike runs so good when it runs. i ran out of gas n kept trying to start it till battery was dead and that is how it got this way. Please and thank-you starter works fine when hooked up to a battery off the bike. what gives?
- I have searched EVERYWHERE that I can think of with no luck 1990 Honda CRX base or hf model manual window reg? I'm not sure if I can fix the one I have. I bought the car new and it is the original regulator. Any suggestions would be greatly appreciated.
- I have a Honda GSV 190 mower engine with a broken starter rope and stud stuck in starter that I can't remove. Any ideas would be great When removing the nuts holding the recoil starter in place the nut on the front of the starter is stuck. When I try to remove it the whole stud come out of the engine. Leaving the engine cover stuck to the starter preventing me from replacing the rope. I have tried everything I can think of to remove it with no luck. Heres what it looks like. http://www.ereplacementparts.com/bolt-stud-h425mm-p-554740.html