I have a 95 honda accord and i have no pressure in the clutch petal?
I have a 95 honda accord and i have no pressure in the clutch petal?
Possibly the slave cylinder is toast.
Check the fluid level in the reservoir. If it has fallen too low the system will not function. Look closely for leaks of fluid around the master cylinder and the slave cylinder. They should be bone dry. If not, replacements are needed. Lastly the clutch release fork may have broken. This is rare but if full movement can be seen at the slave cylinder it's probably that.
Most likely reason is a leak in the hydraulic clutch system at the slave cylinder. Check the clutch master cylinder reservoir.
- NEED GO CART CONVERTED FROM BELT CLUTCH TO CHAIN DRIVEN CLUTCH? I have a 2 seated carter go cart with a 5.5 Honda motor and is belt driven. I'm wanting to convert it to a chain driven system but need to know how. The frame is chain driven but the clutch is belt driven how do I convert the clutch to a chain drive system.
- Karcher Honda Pressure Washer 2400psi Low Pressure? Hello every one I have a Karcher Honda Pressure washer 2400psi, when every I pull the trigger the first time it works fine. Then when I take the vavle unloader and the end where the air filter is on the pump, it works after a while for only one trigger pull. What's wrong?
- Honda CRV 2000, what's wrong? Clutch system retains pressure? I have a problem with my clutch hydraulic system, the system keeps pressure each time you press the pedal, eventually the clutch remains pressed and the pedal stays very hard. If you open the bleed valve on the slave cylinder, everything reset. But the problem is back again after less than an hour.
- Why does my AC fan and compressor clutch stay on and never cycles on and off when i have the AC ON? 2010 honda civic. Recently replaced the compressor because it was shot and i also have the right amount of refrigerant