My honda is having an overheating issue?
I drive a 1989 honda civic EF with a d15 motor. I recently blew a head gasket. It warped the he's so I replaced the head with a y7 head from a 97 honda civic ek. Well, I replaced the thermostat, the headgasket, the water pump, water pump gasket, and timing belt. I even flushed the radiator. It still overheats. On the y7 head I have, there isn't a valve to bleed the coolant. So how can I get air bubbles out if that's the problem? What is every possible thing that you think went wrong? I'm stumped. Lol. It's a 1.5L
HI, did he/you check to see that the y7 head was not warped as well?
- I have a 2014 honda shadow phantom been having issues with my tail light Brake light works but the steady back light isn't working only shines when i brake electric problems maybe? Guessing it isn't connected but can't take the bolts off from the back to get to the electrical to the tail light and not coming off. Some advice on how to get it properly working would be most appreciated
- I have a 1994 honda shadow vlx 600. I've been having charging issues? Could someone have put the positive and negative wires that connect to the battery on the wrong sides? All the batteries online look the same as this one and the cover on the bike only lets you slide it in one way (where the pos is on the right and the neg is on the left).
- My 1995 honda civic is having problems running at idle? My car runs great when i'm driving but when i stop at a stop light, it will bog up and down. When i press the gas, it will run fine again. It is only when my foot is on the brake. It also runs fine when it is in Park. Help me please! I have already replaced the spark plugs.
- I have a 2000 Honda civic si. I'm having brake problems? I have replaced the calipers, rotors, and pads. I have also replaced the master slave cylinder. The brakes do work and I can bring the car to a stop. But the pedal is almost to the floor until the pads make contact with the rotor. I bled the master cylinder and brakes correctly. Fluid comes out of all bleeders so that is not the issue. Does anyone have any ideas?