I have a Honda GSV 190 mower engine with a broken starter rope and stud stuck in starter that I can't remove. Any ideas would be great
When removing the nuts holding the recoil starter in place the nut on the front of the starter is stuck. When I try to remove it the whole stud come out of the engine. Leaving the engine cover stuck to the starter preventing me from replacing the rope. I have tried everything I can think of to remove it with no luck. Heres what it looks like. http://www.ereplacementparts.com/bolt-stud-h425mm-p-554740.html
Hold the bolt in a vice or with vice grips and try undoing the nut
- What is a great starter motorcycle? I have found an '87 Honda CBR1000 for a good price on craigslist, but I don't know if 1000cc's will be too much or not. I really like the look of the bike, and wouldn't mind have it. I have a budget of around $1,000-$1,500.
- Motorcycle starter over heated starter and only the solenoid clicked so i rebuilt the starter n tested it with a battery n it worked fine? Put it back in bike and again only the solenoid clicks… Is there a fuse for the starter or a relay i may have blown? 1988 honda hurricaine 1000F i'm ready to hang it up but the bike runs so good when it runs. i ran out of gas n kept trying to start it till battery was dead and that is how it got this way. Please and thank-you starter works fine when hooked up to a battery off the bike. what gives?
- I have a Honda 1.4 sport 1999 reg and the revs keep going high but there's little power - any ideas? When i first start it its ok but after 15-20 minutes it starts to over rev and the power seems to drop. Any ideas on what could be causing it?
- How to remove a lawnmower engine from the deck of the mower? I have a Honda HRX217 with a bent crankshaft. I picked up another Honda HRX217 with a bad transmission. I want to swap the motor to make a good mower. Yes I have good mechanical ability but I don't like to take apart something without doing some research if I've never done it before.