Honda Shadow Aero, Recommended tire pressure?

I have a 2007 Honda Shadow Aero 750, What is the recommended tire pressure for this? It shows I have 10 psi in the front which looks to be impossible. Because it is not flat or even close when parked and when sat on. (I'm 300 pounds, I think it would droop. And the back says I have 25. How much do I need?

The recommended tire pressure is stamped onto the VIN plate.
The VIN plate is on the forward most part of the frame,
behind the headlight.

Cripes bubba. 29 front, 36 rear

I run 36 front and 38 rear on street tires like your shadow has.

Motorcycle tires tend to have very stiff sidewalls, so they don't "squish" much when almost flat. You need to check your tire pressures before every ride because you will not be able to look at a tire and know if it is flat or full of air.

  • Punctured tire replacement - can I replace only 1 tire - is it safe to replace the PUNCTURED tire only? My 2005 Honda Pilot rear left tire was punctured near the threshhold (ie - sidewall), but still usable. Thus the tire dealer patched it only. Should I replace that punctured tire only? Or should I replace the 2 tires on the same axle? Or even buy a whole set of 4 tires? I'm concerned about safety, and thus your best advice is very appreciated.
  • Honda shadow aero 750 tips and advices? I'm new into motorcycles, and i bought a 2009 Honda shadow aero 750, i wanted to know some tips and advises in maintenance and general walk around just to get me used to the bike
  • Busted my front driver floorboard on 2000 Honda Shadow Aero 1100. What all should I buy? I screwed up and tipped the bike. The right floorboard broke clean off. Can I just replace them with pegs, or do I have to buy the floorboards? Can someone give me some advice on where to buy all the pieces I'll need? It broke off close to the board itself. Also, is this something that I can fix on my own with a good wrench, or should I be taking it in somewhere and having them do it?
  • Karcher Honda Pressure Washer 2400psi Low Pressure? Hello every one I have a Karcher Honda Pressure washer 2400psi, when every I pull the trigger the first time it works fine. Then when I take the vavle unloader and the end where the air filter is on the pump, it works after a while for only one trigger pull. What's wrong?