How do i replace the Bank 1 and Bank 2 02 sensors on a 2006 Honda Pilot?

I've tried looking all over youtube for a tutorial, but can't find one that actually explains what to do!

Put a wrench on 'em. Lefty loosey, righty tighty. Oh yeah, those wire connecty things, gotta unconnect them too.

Everybody wants something for nothing. Go buy a workshop manual for it.

Go to the library and they sometimes have a section full of haynes and chilton etc manuals. Or buy one online.

Or just locate the oxygen sensors, they are on your exhaust, usually you need a special oxygen sensor socket to remove them. Be careful not to twist the wiring too much while youre rotating it. Also if you plan on working on your own car, DON't make ANY mistakes.

Mistakes happen but you want to try to avoid them as much as possible, it could end up killing you if you forget to tighten lugnuts on a wheel or something.

You suck at using a search engine

HI so this is not for the amateur to do. Due to the complexity of what is needed.

If you can't look at the 02 sensors and figure out how to unscrew them and install new sensors I'm wondering how you even decided that they were your problem in the first place! Have you monitored their voltages and switching ties yet?
By the way there are quite a few videos on youtube showing how it's done!