What torque setting do i need to tighten cylinder bolts on my honda nsr125?
What torque setting do i need to tighten cylinder bolts on my honda nsr125? - 1
Usually the Shop Manual gives you that information.
Are ypu working without one?
Buy a workshop manual or after market one before doing ANY major work on a bike
Download the workshop manual from the internet.
Download manual here for free. http://www.productmanuals.org/lp/?category=Honda&utm_network=%7B%7D
- What damage could've been caused from my honda nsr125 overheating? Started overheating so pulled over to stop and coolant has leaked out. Would it be a leak thats caused it as yesterday drove fine no problem but just concerned about any damage thats been caused
- What's the standard pilot and fuel mixture screw setting on honda motorcycle? I have a 1980 honda cm200 that doesn't want to start up what settings should i put the pilot and fuel mixture screw at? So that it can atleast turn on, i have it at 2 full turns from seated for the pilot and 5 turns for the fuel mixture screw but it won't turn on
- Setting the Flywheel timing on a Honda 150cc Lawnmower Engine? I took an old Honda G150 apart and am now putting it back together and I'm not sure how to get the flywheel timed properly. Can anyone just give me a basic walk through on how to time the flywheel?
- How to tighten clutch/friction zone on motorcycle? I bought a used 2013 Honda cbr250r repsol edition motorcycle with just 1100 miles on it yesterday and I keep stalling the bike to point where I had to push it home. The clutchs friction zone is too far out to my finger tips and I have small hands so it causes the bike to stall, What should I do to make the friction zone smaller? How do I tighten the clutch cable? Or do I need to just buy a whole new cable and take it to the shop?