Are there any dual exhaust that would possibiy fit a suzuki gn250? I was thinking an honda xl maybe?
This bike is going to be trail ridden. I've posted about it recently a few times and have been getting great answers!
Cut and shut the existing ones. As long as you plan and measure it that will be more effective than adapting the wrong manufacturers items.
It is very doubtful a Honda exhaust will fit a Suzuki. What is wrong with the original exhaust?
The Suzuki GN250 a SINGLE CYLINDER motorcycle. WHY would you want a "dual" exhaust? That just adds weight and complexity.
This is a small bike with a simple exhaust layout. Rather than try to make another bike system fit, I would use the headers from a DR250, then get a local exhaust place to bend up a middle section to your requirement, then fit a universal muffler
- What would be the best bike for me a yahama yz, Honda cr, Suzuki rm or a Kawasaki kx I want 125cc? I'm 18 and about 5 foot 9, I have had experience with bikes before a 50cc and a 85cc but haven't been off roading on a bike in a while so just looking into getting a off road so what would be the best bike to get
- Does a dual yoshimura exhaust have different sized holes just like on a stock CRF250R? I own a 2006 Honda CRF250R bike which has dual exhaust which comes stock on the bike. For the stock dual, the left exhaust has a slightly bigger hole than the right because of making even airflows. MY QUESTION IS: I want to buy a dual Yoshimura from motosport.com, i'm not sure if they have different sized holes just like stock. And if they don't, does it make a difference?
- What type of exhaust gasket should I use when fitting new exhaust? I would like to install new exhaust system on my car and was wondering if I use the flat oval shape gasket or round conical gasket or both? I'll be installing a backbox and centre pipe. It's a 1998 Honda Civic.
- I'm thinking if doing a project and want to know what would be best with an engine swap? I was thinking of doing a project on a Honda civic, I have seen S2k builds and had decided that I might try to do that rather then the classic K series or B series build, sombly because of the fact I want to try and stand out. I was wondering which motor would be better, the JDM F20C, or the USDM F22C1? I had researched and the only difference I could find was displacement and torque differences. I just want to know what would respond better to mods?