Honda accord 1994 ex abs code 2-2?
Abs light flashed 2 2 when done the test
What does it mean?
I do not think that you have read the code or counting it right. This link contain all of the ABS code for your Accord, the same thing I have in the Factory Service Manual (FSM): As you see: There's no 2-2 code: http://www.ericthecarguy.com/honda-abs-c…
Get the right code then I'll come back to show you. Be best send an E mail to me and I'll rely with all wiring diagrams and instruction as well as other needed material. YA forum only allow sending one diagram so E mail would be best for you. If you do then I'll send a copy of the FSM to you.
Edit: Code 4-2 is the same as 2-2, that's why 2-2 was not including in the diagnostic chart. It's the Left Front WSS (Wheel Speed Sensor) circuit.
Make it short: Inspect the wiring harness, the connector to the L/F WSS and the pick-up ring for the WSS on the half shaft, if the ring, wiring and the connector is good then replace the WSS (Common cause). Clear the code and test drive. I've included a wiring diagram just in case you need it.
- Honda civic ep2 Sport. Wire engine management light to abs? Basically the abs light is being stuborn even after replacing the sensor that was faulty. It went off at first but then has come back on shorty after. Need to pass the MOT and was just wondering which wires are the engine management and abs that go into the dash so I could maybe wire them together?
- Right side of my 1994 Honda accord hood doesn't shut all the way? The left side closes perfectly but the right side seems to not want to close all the way even after spraying Wd40 on the latch, mechanical help please.
- Can I put an ABS CV axle on my non ABS 1998 Honda Accord? Shopping for A front Left CV axle for my 1998 4cyl automatic Honda Accord. Car does not have ABS but all the CV axles I see online do. Would one with ABS work?
- After replacing the ECT sensor for my 1994 Honda Accord EX, check engine light is on and marks code 6? After I fixed the issue with the sensor my check engine light is on and indicates code 6 which is that of the ECT sensor but it's working fine so why is it marking that code? Second ever since replacing that sensor my car won't Start as easy in the morning as it used to. Sometimes after running It for a while and I turn it off, I get this smell of it not using the gas correct because it's smells fresh.