1997 Honda civic won't start?
1997 honda civic won't start it will turn over but won't crank put a turbo on and put new motor in and relay box has power to it and power won't get to the fuel pump battery works perfect and all fuses work I need help As soon as possible
Honda vehicle in the same era are notoriously for ignition switch failure. But the basic has to be checked first like the battery and its terminals/ cables, the starter and its cable/ wires. Look at this video:
The ignition switch:
Check the clutch switch at the clutch pedal if the vehicle has a standard transmission and the park/neutral switch if it's an automatic cause if defected the switch will cause a no crank problem. HTH
If your car is a standard the clutch has a switch check the pedal is directly on top of not i don't really know barely happen to my car now it turns on
"It will turn over but won't crank" Well? Which is it?
- My 1983 Honda nighthawk 650 won't start with the electric start? I recently replaced the ignition coils because the old ones were getting heat soaked and the bike would die, however now the bike won't start with the electric start it turns over fin and the starter sounds fine but it won't start occasionally it ll start when it's cold or try to but I've been having to bump start it in order to ride it. So what's making it do this? Could it be the kill switch? Or something else?
- I have a Honda HRX217 push mower. Backfired when trying to start it, now it won't start? It was running, then I shut it off to open and close a gate, and when I went to start it again there was a really loud backfire and now it won't start. It will sound like it's almost about to start but not. Then get progressively weaker each pull. I changed the spark plug and cleaned the air filter. Any ideas?
- I have a Honda Harmony HRB215 K4 SDA that won't pull start but if I take off the recoil and drill start it, it runs perfect? I have a Honda Harmony HRB215 K4 SDA that won't pull start but if I take off the recoil and drill start it, it runs perfect. I did a compressin test, the pull start only gets the mower to 60psi but the drill gets the mower to 150psi. This mower does have a decompression vale where the ehaust opest about 1/8 of the way. I tore the ead off and checked and cleaned the valves. They don't stick open. Could there be an issue with the decompression valve? Or would it be the piston rings?
- How come my atv won't electric start but will crank if I push start it? 2006 Honda trx. Doesn't have a pull rope only electric start. The starter motor turns over the engine but just won't start but I'll push it down the yard with it in gear and it will fire right up. I'm so confused by this.