My 2000 honda civic ex won't start?
I just did a a motor swap on my 2000 honda civic ex and it won't start I took out my old motor and put in a mini me swap I really don't know much about motors but the car cranks over and I don't know if its the ecu that I have to change or the timing is of but the motor I put in has a y7 block with a y8 head can some one please give me some type of an idea on what could be wrong
I check the main relay and its good I look to see if theirs any loose wires and their also good I don't know why its not starting can it be my ecu that I have to change
Any extra connectors that "hanging loose" or disconnect around the engine? The PCM may be in need of reprogramming or replacement. You'll need to look more in depth into the matter like no spark or no fuel or all of the above.
Read this:
http://easyautodiagnostics.com/honda_dist_ignition/honda_ignition_systems_1.php
Could it be something as simple as the main relay? Have you checked it?:
Edit: Update what you'll find and we'll see as well as other will chime in and help. HTH
- My 1983 Honda nighthawk 650 won't start with the electric start? I recently replaced the ignition coils because the old ones were getting heat soaked and the bike would die, however now the bike won't start with the electric start it turns over fin and the starter sounds fine but it won't start occasionally it ll start when it's cold or try to but I've been having to bump start it in order to ride it. So what's making it do this? Could it be the kill switch? Or something else?
- I have a Honda HRX217 push mower. Backfired when trying to start it, now it won't start? It was running, then I shut it off to open and close a gate, and when I went to start it again there was a really loud backfire and now it won't start. It will sound like it's almost about to start but not. Then get progressively weaker each pull. I changed the spark plug and cleaned the air filter. Any ideas?
- I have a Honda Harmony HRB215 K4 SDA that won't pull start but if I take off the recoil and drill start it, it runs perfect? I have a Honda Harmony HRB215 K4 SDA that won't pull start but if I take off the recoil and drill start it, it runs perfect. I did a compressin test, the pull start only gets the mower to 60psi but the drill gets the mower to 150psi. This mower does have a decompression vale where the ehaust opest about 1/8 of the way. I tore the ead off and checked and cleaned the valves. They don't stick open. Could there be an issue with the decompression valve? Or would it be the piston rings?
- Will starter from an automatic 2000 Honda civic LX fit on a automatic 2000 Honda civic HX? The lx is a 5 gear transmission and the hx is a CVT transmission. With the starter fit? Mine went out on my hx