Having problems with a 2002 honda accord open or short circuit connection, poor electrical connection and?
When it runs for about 15 to 20 miles stops complete when driving it, then I need to wait about 30 minutes and the car will start again'
When it runs for about 15 to 20 miles stops complete when driving it, then I need to wait about 30 minutes and the car will start again'
Having problems with a 2002 Honda accord LX open or short circuit connection, poor electrical connection and?
- 95 honda shadow vlx600 electrical problems? So I took it out for a ride this morning and it starts up fine, shifts fine, accelerates and does everything it's supposed to. I always have it on a trickle charger when not riding. Tested the battery after the incident and it came out to be 12.6 off the bike. I rode it for about 10 minutes, I started to pull into the parking lot and it completely shuts down on me, no lights, no dash, no power no nothing. Any suggestions? I was told it could possibly be the ignition switch?
- I have a 2000 Honda Crv with an electrical short? I have a 2000 Honda Crv that has a short, if it sits overnight, it will run the battery down to being dead I put the multtestor on it and it shows an excessive draw in the condenser fan fuse line. I put a new condenser cooling fan on it and it still shows the same.Had battery tested, it is fine. What could be wrong?
- Help me! Code P2A00 Oxygen sensor circuit range/performance bank 1 Sensor 1 2008 honda Crv ex? I have an 2008 Honda crv Ex and this code came up "Code "P2A00" Oxygen sensor circuit range/performance bank 1 Sensor 1 i want to replace it myself because i know its simple and the dealer wants to charge me over $300 and i can do it for half the cost when i looked it, it has two sensors together one closer to the engine and the other a bit more behind it i don't know with of the two it is.
- I have a 2000 Honda civic si. I'm having brake problems? I have replaced the calipers, rotors, and pads. I have also replaced the master slave cylinder. The brakes do work and I can bring the car to a stop. But the pedal is almost to the floor until the pads make contact with the rotor. I bled the master cylinder and brakes correctly. Fluid comes out of all bleeders so that is not the issue. Does anyone have any ideas?