1993 Honda Civic Engine Won't Start?
It won't start unless I turn the key into the "on" position and then switch it "off" several times. Then once I do that it starts up easy. Doesn't ride rough or anything when I get it started.
Anyone got an idea of what could be wrong with it?
*Spark Plugs, Spark Plug Wires, and Valve Cover Gasket/Grommets were just put in and it didn't solve the issue*
Check the ignition switch: The following link and video are for 95/98 Civic but it's the same for your Civic:
http://techauto.awardspace.com/ignitionswitch.html
Is the engine turning over? If not, most likely it's your battery going out. If it's not turning over, it could also be a electrical problem.
- 2004 Honda Pilot Cranks but won't start if I press the gas when starting it starts.Engine lights is off,? Maintenance required is on but when I reset the lights turned off and everything works for now? What would be the problem? 1. I'm thinking it is the Timing belts slips 2. Relay maybe lose 3. Crank position sensor lose What would be the reason trying to get opinion and will look into it whatever is the best possible problem.
- My 1983 Honda nighthawk 650 won't start with the electric start? I recently replaced the ignition coils because the old ones were getting heat soaked and the bike would die, however now the bike won't start with the electric start it turns over fin and the starter sounds fine but it won't start occasionally it ll start when it's cold or try to but I've been having to bump start it in order to ride it. So what's making it do this? Could it be the kill switch? Or something else?
- I have a Honda HRX217 push mower. Backfired when trying to start it, now it won't start? It was running, then I shut it off to open and close a gate, and when I went to start it again there was a really loud backfire and now it won't start. It will sound like it's almost about to start but not. Then get progressively weaker each pull. I changed the spark plug and cleaned the air filter. Any ideas?
- I have a Honda Harmony HRB215 K4 SDA that won't pull start but if I take off the recoil and drill start it, it runs perfect? I have a Honda Harmony HRB215 K4 SDA that won't pull start but if I take off the recoil and drill start it, it runs perfect. I did a compressin test, the pull start only gets the mower to 60psi but the drill gets the mower to 150psi. This mower does have a decompression vale where the ehaust opest about 1/8 of the way. I tore the ead off and checked and cleaned the valves. They don't stick open. Could there be an issue with the decompression valve? Or would it be the piston rings?