Busted my front driver floorboard on 2000 Honda Shadow Aero 1100. What all should I buy?

I screwed up and tipped the bike. The right floorboard broke clean off. Can I just replace them with pegs, or do I have to buy the floorboards? Can someone give me some advice on where to buy all the pieces I'll need? It broke off close to the board itself.

Also, is this something that I can fix on my own with a good wrench, or should I be taking it in somewhere and having them do it?

http://www.bikebandit.com/oem-parts/2000-honda-shadow-aero-1100-vt1100c3-step/o/m151363sch101120

Buy the parts OEM at a dealership or aftermarket from bikebandit. Easy to replace. Its common sense stuff.

  • If i make a wire harness will it work with out pulse generator and icu on 85 1100 honda shadow? If i just make direct line from stator to rectifier to starter selonoid and coils will it be fine with out the pulse generator and the 2 icm/icu? I want to eliminate a bunchof stuff on it and i was wondering if that could go as well. It was a mess when i bought it i will figure it out if it must stay but i just need to know if it can go because it will be less of a headache if i can keep it going with out it.
  • Honda Shadow Aero, Recommended tire pressure? I have a 2007 Honda Shadow Aero 750, What is the recommended tire pressure for this? It shows I have 10 psi in the front which looks to be impossible. Because it is not flat or even close when parked and when sat on. (I'm 300 pounds, I think it would droop. And the back says I have 25. How much do I need?
  • Honda shadow aero 750 tips and advices? I'm new into motorcycles, and i bought a 2009 Honda shadow aero 750, i wanted to know some tips and advises in maintenance and general walk around just to get me used to the bike
  • Can you put harley wide glide forks on a honda shadow ace 1100? Both forks are 41mm. I'm trying to put a 21" front tire on the bike and I'm weighing my options on what I should do. If the forks can set into the triple tree with not much problem Luke only having to make shims then that's the way to go.

Add Comment